|
|
|
|
|
#1
05-30-2006, 06:53 AM
|
|||||
|
|||||
I did get a bad membrane once Sean, went through a whole lot of quiz questions from Aquasafe to verify that. You should contact them if you think that might be the problem.
__________________
http://www.canreef.com/ftotm/sept05/index.php 
|
|
#2
05-30-2006, 02:41 PM
|
|||||
|
|||||
|
reply
I second that, I didn't get instructions with mine either. I just emailed them and they sent me everything I needed to know via email.
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041
|
|
#3
05-31-2006, 02:37 AM
|
||||
|
||||
|
yah i have been in contact with them for a bit, they now want me to measure the pressure coming out at different locations, cept i dont have one of those pressure guages, might have to get one.
On another note i mentioned to wendell about my problem and he suggested putting a valve on the waste watter line and restrict it to create some back pressure (presumably to force it through the membrane) which makes sense to me. I have done that, and my TDS was at abou 34, but that was right after doing it so I am letting it run for a while to see what happens... does this sound like a good idea? thanks again for all the help!
__________________
Sean
|
Hybrid Mode
