![]() |
|
#1
|
|||||
|
|||||
![]() Is that the waffle/pancake thingy?
![]()
__________________
http://www.canreef.com/ftotm/sept05/index.php |
#2
|
||||
|
||||
![]() well i dont have the white puck thing, so i dont think thats the problem
![]() After spending most of the day trying to get it to work, I am starting to think there is something wrong with the RO membrane, as its basically the only thing it could be. There is a good amount of water entering the RO unit, the unit is sitting snug into the bottom (the end with the 2 o-rings is down). There isn't supposed to be anything else in the RO canister (ie washer etc) other than the ro membrane itself, correct? I am getting plenty of waste water but NO ro water. arg! any ideas?
__________________
Sean |
#3
|
|||||
|
|||||
![]() This thing. The other tube end of the ro unit with the metal nut connects to it.
![]() |
#4
|
||||
|
||||
![]() yah i definatley didn't get one of those, I had it hooked up properly before without one. Then I swapped out all the filters and got nothin.
__________________
Sean |
#5
|
|||||
|
|||||
![]() I'm out of ideas then.
|
#6
|
|||||
|
|||||
![]() I did get a bad membrane once Sean, went through a whole lot of quiz questions from Aquasafe to verify that. You should contact them if you think that might be the problem.
__________________
http://www.canreef.com/ftotm/sept05/index.php |
#7
|
|||||
|
|||||
![]() I second that, I didn't get instructions with mine either. I just emailed them and they sent me everything I needed to know via email.
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041 |