|
|
|
|
|
#1
03-22-2006, 09:45 PM
|
|||||
|
|||||
I checked through the thread again, and cannot find the reference anymore. There was information about a hard plastic curved bulkhead, but I cannot find it anymore unfortunately.
Give the uniseals a try, let us know how they work out for you. Read this link first, they might leak on thin material, and I am guessing your skimmer body is pretty thin. http://www.aquaforums.com/forums/lof....php/t293.html Last edited by TheReefGeek; 03-22-2006 at 09:49 PM. 
|
|
#2
03-23-2006, 01:34 AM
|
|||||
|
|||||
|
I am going to try and find the curved bulkheads. I don't trust the uniseal because if I accidentally bump into it, the seal may losen and leak. Failing to find the bulkheads I will try to find some thick rubber bushing or just end up making something like Tony mentioned.
|
|
#3
03-23-2006, 03:39 AM
|
|||||
|
|||||
|
I've used the common type bulkhead that you get from Hydroponic stores on various sized containers, without problem.
Measured a small one I've got, it's for 1/2" tubing (barbed) with a bulkhead face of 1.25". Looking at it against my ASM G3, could see using it on the skimmer without overly distorting the chamber. A hydroponic store might even have smaller but still sufficient for a skimmer recir mod.
|
|
#4
03-23-2006, 02:20 PM
|
|||||
|
|||||
|
Let us know if you do find the curved bulkheads.
|
Hybrid Mode
