|
|
|
|
|
#1
02-01-2006, 04:56 AM
|
|||||
|
|||||
Quote:
 one suggestion for your tube cutting jig is to make your end larger. you need it to be a little bigger than the biggest tube you are going to cut as you have to ensure if you are cutting your tube and it has a high spot it has to remain in contact at all times with your end plate to ensure the cut stays strait.Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive. 
|
|
#2
02-01-2006, 12:19 PM
|
||||
|
||||
|
I think you are right about increasing the size of the end plate. So far I have only tried 6" tube. It's kind of nice to have no more fear cutting tube. One can even cut with one hand.
The miter slide is very accurate and adjustable. No wiggling in the table slot. Found it at LeeValley.
|
Hybrid Mode
