![]() |
|
#1
|
|||||
|
|||||
![]() Well, he didn't make it
![]() ![]() going to wait a couple of months, and perhaps try a BTA. I did a 5 gallon water change, I am changing my quick filter every 12 hours or so, and replaced the carbon in the quickfilter. I will be changing another 5 gallons when I get home. My skimmer does not seem to be working. the inside of the colection tube on top gets really dirty, but nothing rises to the top of the tube?? I have lowered the tube all the way to the bottom, with still no skimate? The tank is really cloudy after the Anemone "incident" so I know it should be pouring out the skimate......... weird? Any suggestions. |
#2
|
|||||
|
|||||
![]() I guess I should really start a new thread with this??
Robb |
#3
|
|||||
|
|||||
![]() no this is fine, you still need help
![]() If your water is cloudy, I'd definitely be doing water changes, probably a 20-30% water change to start and test all your parameters to make sure nothing else is going on. And run carbon as well ![]()
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. |
#4
|
|||||
|
|||||
![]() Thats really too bad about your sebae.
![]() if its any consolation, the creatures don't fair well in travel sometimes and it was most likely doomed from before the day you bought it.
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041 |
#5
|
||||
|
||||
![]() Take the time to find a healthy one. With the right tank conditions they are very hard to kill.
__________________
Current tank: 120g 30g fuge 2x400w MH 220VHO |