Refuguim

Raf · #1 01-06-2006, 05:37 PM

Can you switch the impellar for one from a smaller model? Such as a 150 or 200? I think that reduces the flow...

-Diana

fishface · #2 01-06-2006, 05:43 PM

Quote:

Originally Posted by Raf

Can you switch the impellar for one from a smaller model? Such as a 150 or 200? I think that reduces the flow... -Diana

can't do it...the 110 has its own impeller that none other fits. i angled the baffle about 5 degrees and drilled 6 holes near the top...having done this i can use the pump at full flow and not have spill over. i tried removing the black collar and found no difference personally.

darryl

Samw · #3 01-06-2006, 06:12 PM

I haven't tried it but what if one cuts a few of the impeller blades off?

fishface · #4 01-06-2006, 06:38 PM

Quote:

Originally Posted by Samw

I haven't tried it but what if one cuts a few of the impeller blades off?

tried that too...definately works but if you cut off too much then the only thing you can do is replace it

so be advised to cut slowly if you go this route.

danny zubot · #5 01-06-2006, 07:09 PM

Quote:

I haven't tried it but what if one cuts a few of the impeller blades off?

That would be like taking the weights off your car tires. Impellars need to be balanced other wise they are loud and ineffecient.

fishface · #6 01-06-2006, 10:13 PM

Quote:

Originally Posted by danny zubot

That would be like taking the weights off your car tires. Impellars need to be balanced other wise they are loud and ineffecient.

not from my experience...if it's done carefully, it can be done successfully. i do agree however that if the blades aren't cut or shaved evenly you could have problems.