seaclone help

[Raf]

this was exactly why i replaced my seaclone with a prizim.....

[danny zubot]

Try placing a piece of foam on the return water slide thing to cut down on the bubbles.

Ulitmately, fine tuning is the answer. Or upgrading.

[scotchy]

Look for the bioball mod. I beleive it's somewhere on this site, if not it's on reef central. Scrap the air valve that came with it and replace it with a good needle valve from any local pet store. The seaclones biggest problem is that it flows too much water for the little space it has and it ends up forcing bubbles through the second chamber. The bioball mod not only slows the flow but also helps produce finer bubbles and get you better performance. My opinion based on my experience only though.


Scott

[deep6er]

I had the same problem with mine but further resurch found that any water conditioners dont work well with skimmers and will cause micro bubbles so i dont use any water conditioner any more. i would say turn it off for a day or so and slowly turn it on or place a foam under the output. I tryed this method too but it worked only about 75%

good luck

[JasonJ]

i have decided to sell the seaclone.
i find that the maxijet1200 is too powerful.
my clown gobies are struggling to swim.
do u guys have any advice on what skimmer to get for a 20gal?
prism? remora?

[Ruth]

Between those 2 skimmers I would definately go with the Remora.

[danny zubot]

when I had my Seaclone I simply swapped the maxi jet 1200 for a maxi jet 900 and it worked like a charm. I also used a good needle air valve for better control.