Regulator question

[reefburnaby]

Hi,

Are you using a proper wrench to tighten the pressure fitting ? I hope you didn't just tighten it with just your fingers.

There is suppose to be a gasket between the two mating surfaces. Try flipping the gasket around and see if it works better.

Don't use teflon on CO2.

In any case, if you can get it to work then bring it to Liquid Air, any compressed air supply store or welding supply store. They can help you figure out the problem.

Hope that helps.

- Victor.

[ 02 February 2002: Message edited by: reefburnaby ]</p>