Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > DIY

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #2  
Old 05-17-2005, 06:24 PM
muck's Avatar
muck muck is offline
Member
 
Join Date: Mar 2004
Location: Edmonton, AB (West)
Posts: 4,329
muck is on a distinguished road
Default

1. You could use the 2 x 15 amp breaker. If you only use one side of it it will still trip like normal. Chances are you will not need to use this though since you have 4 other circuits to use. (see below)

2. All this means is you have two seperate circuits both 110V. One being the red wire and the other being the black wire. They just happen to share the same neutral. If one circuit trips for some reason the other will as well because the breaker is connected.

3. This would be the same as number 2. Only difference being is that if one trips the other will not because the breakers are not connected. The green wire most likely is a ground. Check if it goes to a ground bar in the panel.


Sounds like you will have lots of dedicated circuits for your fish room.
Id come help you out but its a bit of a drive for me...
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 10:08 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.