Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > Other > Lounge

Reply
 
Thread Tools Display Modes
  #1  
Old 05-12-2005, 01:48 AM
Shy_Koi's Avatar
Shy_Koi Shy_Koi is offline
Member
 
Join Date: Nov 2003
Location: Manitoba
Posts: 118
Shy_Koi is on a distinguished road
Default

Must be an Aquasafe day, I just set mine up this afternoon
Ran into a couple of glitches...
The system had to go into my basement rather than the recommended under sink installation. The red feed water hose came supplied as 2 ft and I needed 25" to reach the nearest cold water line (it came with a factory crimped fitting, so I couldn't just replace the length of hose). Fixed it by extending the hanging bracket with a 2x4. Now I just have to remember to duck when I go under this particular area...

The yellow waste water line was even shorter, but I modified it by sticking it into a length of aquarium siphoning hose and then running it into the drain.
The only 2 fittings that I actually had to attach, leaked like sieves. Ran to the local co-op but they had just sold the last container of plumber's compound (Ed's 1st choice) and only had teflon tape left (Ed's last choice)

8 tries later and the teflon taped fittings only "slightly" leak now
I've given up and sat them in a basin...

My house water pressure is pretty poor: ~40 and the tds is ~290. That combined with a very cold water water feed, is presently giving a pretty slow RO/DI output, compared to a strong waste water output. I've not measured it yet, but it's prob close to 8:1
Just happy I finally got this thing set up

~Tamara
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 09:42 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.