looking for a needle valve for kal stirrer

[Skimmerking]

Originally Posted by mseepman

Haha no I didn't have to...but I might not have used it for the same thing you did and was unsure if the adjustment valve on this would work for you.

Strange that they want so much shipping...I'm a Prime member and shipping for that was listed as free.

its always something mark i have prime aswell but cant seem to find that needle valve that i posted its a US thing i think

[hillegom]

I think it is this one:
https://www.usplastic.com/catalog/it...related-slider

[Skimmerking]

yes that is the one they want 16 us for it and 32 us to shipp

[smokinreefer]

This is for a kalk-stirrer?
Just going to do a slow drip?
Not the same, but would a 1/4" irrigation valve work? I used one in past for a calcium reactor.

https://www.lowes.ca/product/drip-ir...B&gclsrc=aw.ds

[Skimmerking]

Originally Posted by smokinreefer

This is for a kalk-stirrer?
Just going to do a slow drip?
Not the same, but would a 1/4" irrigation valve work? I used one in past for a calcium reactor.

https://www.lowes.ca/product/drip-ir...B&gclsrc=aw.ds

Hey man yes its for the ice cap kalk stirrer and its a drip every 3 sec i have tried others just cant seem to get it to work the needle valve you mean for the cal Reactor? The little silver one that is hooked up to the air for bubbles


Oh those ones i just looked at the link how did you find the?

[smokinreefer]

it did the job.
I had it tee'd off my return.
If I recall I used a JG 1/4 shut off in-line before the valve. To slow down the flow first, then fine tune with the valve.
I think for what my purpose was and yours, the lack of precision is acceptable.
my flow rate was faster tho.

only thing I would be weary of with a slow drip kalk effluent is the potential for precipitate to form at the exit tubing.

[Skimmerking]

Originally Posted by smokinreefer

it did the job.
I had it tee'd off my return.
If I recall I used a JG 1/4 shut off in-line before the valve. To slow down the flow first, then fine tune with the valve.
I think for what my purpose was and yours, the lack of precision is acceptable.
my flow rate was faster tho.

only thing I would be weary of with a slow drip kalk effluent is the potential for precipitate to form at the exit tubing.

yes just have to make sure to clean the hose with some hot water