![]() |
|
#1
|
|||||
|
|||||
![]() Starting bare bottom is definately your safest option.
I recommended using as much old water as possible as this will, in my opinion, cause the least amount of stress to your corals. Whatever new water you need to use, make sure you test and dose it first to get the big 3 matching your old water - Alk, Ca and Mag. And aerate it well to off-gas the CO2, bringing the pH up. I do this overnight as it's part of my routine before a WC. I use a Maxijet breaking the surface for this. Last edited by gregzz4; 01-27-2018 at 09:12 PM. |
#2
|
|||||
|
|||||
![]() Quote:
1. How do I pour the sand evenly out of my bad without getting it all over my LR and corals? 2. How do I get the sand in all the tight spaces (caves, overhangs, tunnels etc). 3. How long do I have to wait before I can start adding sand? 4. Can I add my whole 1” sand bed at one time? 5. What bacteria additive should I add to the new tank?
__________________
300g Basement Reef - April 2018 |
#3
|
||||
|
||||
![]() when I moved my stuff from house to house I made sure not to interrupt the rock in the sand until I was had 90% of the water out and discarded the rest. i made sure to add a bottle of start-up bacteria and didn't add coral or fish until the tank was at temp in an effort to keep things less abrupt. in the end I didn't lose anything and it wasn't more than a week before things looked good again.
as for sand, I used all new sand adding just enough for my wrasses and then basically added the rest over a few weeks slowly in a Tupperware so It didn't dust my tank out completely. Last edited by ReefMadness; 01-27-2018 at 11:42 PM. |
#4
|
|||||
|
|||||
![]() You didn't answer a question I posed to you awhile back ... Is this going to be a 1 day transfer? If not, it'll be a piece of pie, or easy as cake ...
![]() There are others here who I hope chime in as I'm no expert ... ![]() Ok well it seems that the safest is adding sand after the fact. A couple questions regarding this method: 1. How do I pour the sand evenly out of my bad (hand?) without getting it all over my LR and corals? I use a small measuring cup with the pumps off. Bucket full of sand wet with some tank water nearby and scoop with said cup. Then slowly dunk the cup in the tank 'till it's submerged. Go near the bottom and tip the cup, pouring as you go. Gravity will do the rest. It will literally 'pour out'. A turkey baster after the fact is good to clean sand off stuff. 2. How do I get the sand in all the tight spaces (caves, overhangs, tunnels etc). As above. Pour it near the space and the volume will fill it in. It will find it's way into spaces. Use your hand to push it around, wave it around. You'll be surprised how easy it is. 3. How long do I have to wait before I can start adding sand? I'd personally wait a couple weeks. Others may tell you different. After adding sand, the system will be cloudy overnight. Changing socks will help. Don't panick. It will eventually clear the next day. 4. Can I add my whole 1” sand bed at one time? If you're starting out Bare Bottom, I don't see why not. As long as the new sand is clean and 'new'. Rinse the heck out of it in (hopefully) a laundry tub using a small (2g) bucket. Rinse a couple gallons at a time with the tap running to 'overflow' the bucket. Swirl it around in the bucket with your hand, pour it out. Repeat many times. You'll be surprised how 'cloudy' new sand is. You'll never rinse it 'clear'. I do 5-6 rinses per 'clump' 5. What bacteria additive should I add to the new tank? My suggestion was Seachem Stability. Follow the bottle directions. 5ml/10g tank water on day one. Then 5ml/20g tank water each day for 1 week. This is to get you over the Ammonia hump. Any use after 1 week is a waste of money, unless you have am Ammonia problem. And you're only doing this if you're adding livestock. It will not seed the tank. It's only meant to combat Ammo from livestock. |
#5
|
|||||
|
|||||
![]() Quote:
I picked up some AmQuel Plus to dose and assist with any ammonia that presents. I will pickup a bottle of the seachem stability to use for the first while as well. I’m also goIng to try my best to transfer LR from on tank in to the another keeping the LR ‘wet’ to try and prevent further die off. The last tank transfer I did the LR was out of water for approximately 15 mins. If majority of the ammonia spikes are caused by live sand die off I’m prepared to go bare bottom for the first bit. I will have to find a jar for the goby and dual pistols if I go this route. Thanks for chiming in gregzz, it’s appreciated!
__________________
300g Basement Reef - April 2018 |
#6
|
|||||
|
|||||
![]() I didn't mean for that to show up ... "You didn't answer a question I posed to you awhile back ... Is this going to be a 1 day transfer?"
I was in the middle of a post re-write and lost the site connection ... I saw that you stated a 1 day effort in your first post. Since then, I read through all the post again and left a post that has since disappeared .... argh |
#7
|
|||||
|
|||||
![]() Need to eat dinner/spend time with my wife
Later ... |
#8
|
|||||
|
|||||
![]() No sweat! Happy wife equals happy life and more coral
![]()
__________________
300g Basement Reef - April 2018 |
![]() |
Tags |
coral, fish, stress |
|
|