![]() |
|
#1
|
|||||
|
|||||
![]() As I said before I am not using any kno3 as I am not sure what it will do in terms or growing algae... I went to point Roberts on the weekend and picked up some stump remover, I am going to do some reading before mixing it up and putting it on the doser. I also tested my nitrates last week and finally after adding some dry rock that was not cured I have some readings of nitrates but it is in the range of 0-5ppm so I will continue to test and as it falls I will add some of this nitrate.
__________________
Always looking for the next best coral... 90g starphire cube/400mhRadium20k/2 XHO/2x27w UV/2x39w T5/ 3 Trulumen led strips |
#2
|
|||||
|
|||||
![]() Quote:
For me, KNO3 is a better choice to raise your nitrate. It will not only raise your NO3 but will also raise your Potassium (K) level a little bit which is good for coral coloration. You also need to check your K level to make sure it is on the 400 range. It is also easy to dose and calculate the levels, check on the article written by Randy Homes Farley. But again, dose slowly... |
#3
|
|||||
|
|||||
![]() Quote:
__________________
Always looking for the next best coral... 90g starphire cube/400mhRadium20k/2 XHO/2x27w UV/2x39w T5/ 3 Trulumen led strips |