biopellet flow

[htfn]

Sorry to interrupt.
I set mine up about 3 weeks ago and I still don't see any change. I heard cyano should comes up for short term. I also use TLF reactor 150 and maxi jet 1200. I see pellets are tumbling but more likely bottom part and upper part is still tumbling but I don't think it's aggressive. Am I doing something wrong? Would be appreciate if anyone can fix my problems.
Thanks

[The Grizz]

When I was running the TLF150 I started with a MJ1200 with about 250 ml of pellets but found the flow was not enough so I jumped up to a MJ1800. Now I am using a NextReef MR1 and a Ocean Runner 2500. I did not have any cyano show up after running them.

[htfn]

OK so maxi-jet 1200 is not enough flow. I guess I searched wrong place then. Do you think flow rate should be more than 350g/hr?

[Bblinks]

Originally Posted by htfn

OK so maxi-jet 1200 is not enough flow. I guess I searched wrong place then. Do you think flow rate should be more than 350g/hr?

I honestly don't think you need anymore than that. The problem I had with TLF is the inlet and outlet, TLF comes with 1/2 inch barb hose but for pellets you need 5/8 or even 3/4 barbs so you can get the flow that you need without grenade the reactor. If I were you I would really look into a smr1 or a vertex reactor. If thats not an option, try to find some thing used. All else fails, throw a bigger pump on it and make sure you remove the foam in the TLF, re-tap the barb fitting so you can put a larger diameter hose an try again. Be patient and let I run for awhile. I have had very good results with running the pellets. The smr1 with the pump costed me around less than 200 with tax.

[htfn]

Yes I already remve foam and install mod both bottom and upper plate, but I did not know I have a reactor problem. What you pay, what you get, right? I will serch the other reactor or try to put a larger hose.
Thanks

[reefan]

I use the large Vertex reactor and it works fine, no clumping.

[The Grizz]

The NextReef MR1 has 1/2" barbs and works great.

[jonnyjamms]

I set about 3 weeks ago, I have not seen any change. I heard that over the short term should cyano. I also use copper and aluminium composite reactor and the maximum 150 jet 1200. I saw the ball was dropped, but more likely at the bottom of the upper is still rolling, but I do not think it is positive. What am I doing wrong? Would be grateful, if someone can solve my problem.