Grizz's 8' shallow sea

[xtreme]

If it were me I would get a 2" bulkhead then reduce it to 1.5" outside the tank if that would work for your application.

[The Grizz]

Originally Posted by xtreme

If it were me I would get a 2" bulkhead then reduce it to 1.5" outside the tank if that would work for your application.

I will check to see what I have for bulk head in my stock if I got one that would work. It is for the feed to the pump for my closed loop so going down to 1 1/2" at the pump would not be an issue.

[superduperwesman]

Very clean plumbing. Looks good. No Herbie?

[The Grizz]

Originally Posted by superduperwesman

Very clean plumbing. Looks good. No Herbie?

No I thought I would try the durso standpipe on this tank. I am not going to glue the bottom of the stand pipe into the bulk head untill I test it to see how it works.

[xtreme]

Well I do have a 45mm bit as well. If you are in town you can come a grab them both. Only thing is I'd like to have the 45 back since I might need it again. Even if you returned it in the next couple months that would be fine, I won't be using it anytime soon.

[The Grizz]

Originally Posted by xtreme

Well I do have a 45mm bit as well. If you are in town you can come a grab them both. Only thing is I'd like to have the 45 back since I might need it again. Even if you returned it in the next couple months that would be fine, I won't be using it anytime soon.

That would be sweet. I hope to be there for work next week if all goes to plan. Shoot me a pm with your contact info. I will get them drilled and back to you fairly quick.

[BWI]

nice work.. if you can try to pump the pump straight without that elbow. Puts strain on the pump.

great work!

[The Grizz]

Ya I have not glued the line from the pump to the tee so I can still change it. I was hoping to keep the pump in close & I know it would put strain on the pump. I will probably change that.