Who drills holes in Victoria area?

[Midknight]

Hey Kabong,

What bit would you use on the dremel?

[Todd]

I was reading an old post and come apon this link. Looked alot easier then doing the dremil method. But I have done neither so I can't comment on the effectiveness of either method.

http://cgi.ebay.com/40mm-Diamond-coa...QQcmdZViewItem

[Kabong]

You have to use the diamond tipped bits with the dremel
I used the 7144

Originally Posted by Todd

I was reading an old post and come apon this link. Looked alot easier then doing the dremil method. But I have done neither so I can't comment on the effectiveness of either method.

http://cgi.ebay.com/40mm-Diamond-coa...QQcmdZViewItem

These guys were out of stock for awhile, But now that they have them in again. These are totaly the way to go.