|
|
|
#11
05-11-2013, 12:14 AM
|
||||
|
||||
Yeah... the crimp type are a different animal all together. They have a nice wire stripper for it that will only strip back what’s needed.
My LED’s are spaced fairly evenly, so I wasn’t too worried. I have a row of LED's on each side, with clusters down the middle of the heatsink. I have the sensor centered width wise, but slightly offset length wise, so as not be directly under the fan. I also heat shrinked each leg on the sensor, then placed another heat shrink over everything, so that it covered up all of the legs, and what part of the sensor that was sticking out of the heatsink..... Hope that makes sense. (The sensor ended up behind one of my clusters)
__________________
All spelling errors are considered intellectual property of its owner, and are not to be tampered with 
|
Threaded Mode
