G&D's Foray Into a 90G Tank (Take One)

[gridley]

Deborah and I have spent the past weeks trying to get parts for the plumbing, trying to get time to do the plumbing and trying to just live life. In other words - this has taken a lot longer than I thought it would. In the past few weeks we did manage to get the sump into place and make some aluminum brackets to mount a florescent light that I picked up used.

However . . . I think that we have completed the plumbing - at least "take one". I assembled the last of the fittings and glued everything up tonight. Below are pictures of the sump with the plumbing in place.



We were somewhat limited by the original design of the tank (it was a used tank). We have a 1 1/2" main drain using a gate valve to adjust the flow. There was no emergancy drain so we added a 1" drain but had to plumb that out the side of the overflow and on down. Our return line is a 3/4" line.





We have left room to the right of the return line to mount carbon and GFO reactors to the side of the stand.

Tomorrow we will do a test with fresh water and if all goes well we will get serious about doing the aquascaping. If it doesn't go well - we will be doing "plumbing - take 2". Hopefully (and maybe I'm dreaming or delusional ) we will fill it with salty water by the end of next weekend.

We have also been working on our RO/DI station. It is set up in furnace room but we are not finished and although we can produce water, there are lines running all over the place - so until I get a few more fittings to make it look neater - no pictures!