Acrylic Router Bits - Canreef Aquatics Bulletin Board

06-27-2008, 05:23 PM

sphelps

Member

Join Date: May 2006

Location: Lyalta, East of Calgary

Posts: 4,777

looks to me like the feed rate is too high. It's hard to see from the picture but does the edge seem to show an internal bubble like texture?

I would try removing 1/32, increase the router speed and experiment with different feed rates. You'll get it, it just takes time to figure out what works best.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT. The time now is 05:08 AM.