ok so i feel a little bit stupid but i'm posting this to help others in case they have the same issue. i was settting up the analog and 1st digital powerbar properly but where i was going wrong is once i programmed the 1st digital bar i was daisy chaining the 2nd to it to program the 2nd digital bar. what i figured out laying in bed at 2am was that once the 1st digital bar is programmed i disconnect it from the computer and then hook the 2nd bar into the computer to program it. once both are programmed then you daisy chain them together. hope that makes sense.
|
10-17-2007, 11:14 PM
Threaded Mode
