Profilux II plus aquarium controller

[Matthias Gross]

Hi Moose

the numbers of the analog power bars are ALWAYS determinded by the western socket where they are plugged in. The numbering of the analog bars CAN'T be changed. That means for analog powerbars:
- plugged in S1-S4: the sockets have numbers 1, 2, 3 and 4
- S5-S8: numbers 5, 6, 7 and 8
and so on

The numbering of digital powerbars can be changed. Default is 1...6.

This means for your setup:
- connect analog powerbar to S5-S8 -> these are sockets 5...8
- program the digital powerbar #1 to be numbered 9 ... 14
- program the digital powerbar #2 to be numbered 15 ... 20
(while programming: connect only the powerbar which should be programmed, otherwise both powerbars are programmed)

This is only an example configuration; any other numbering can be assigned if you want to. But then make sure that there are no socket numbers twice - then they would switched simultaneousl.y