Sodium Clog

reefwithareefer · #1 02-22-2016, 01:07 AM

Does any one have the same issue as me. I dose my sodium every 4 hours. After a week or so the sodium starts hardening at the end of the tube, causing the tube to fully clog. I left the end of the tube out of the water and submersed it, either way it clogs.
Any solutions?

Not that I think it is relevant, but I use Randys 3 part, The tube ends for each part, are about 3 inches away from one another and each part is dosed hours apart from one another..

emerald crab · #2 02-22-2016, 04:15 AM

I assume that you're talking about the alkalinity solution. My fix for the solution hardening at the end of the tube was to mount the ATO tube on top of the alkalinity one and slightly back. Whenever the ATO kicks in it rinses the end of the Alk one.

spit.fire · #3 02-22-2016, 04:29 AM

Quote:

Originally Posted by emerald crab

I assume that you're talking about the alkalinity solution. My fix for the solution hardening at the end of the tube was to mount the ATO tube on top of the alkalinity one and slightly back. Whenever the ATO kicks in it rinses the end of the Alk one.

What if you top off is on a float valve

albert_dao · #4 02-22-2016, 04:31 AM

You can use a more dilute solution of sodium carbonate.

Animal-Chin · #5 02-22-2016, 10:22 PM

I've been dosing for over 2 years and have never had build up. I'm guessing your ratio of sodium carbonate to water is to high?

reefwithareefer · #6 02-23-2016, 01:51 AM

Quote:

Originally Posted by Animal-Chin

I've been dosing for over 2 years and have never had build up. I'm guessing your ratio of sodium carbonate to water is to high?

That falls into what Albert was saying as well.

I use 2 cups of sodium per gal of fresh water, as per Randy Holmes recipe, so not sure if it is too strong .....It does makes sense to dilute it down and dose more often. I will try that.

Thanks guys...

reefwithareefer · #7 02-23-2016, 01:48 AM

Quote:

Originally Posted by emerald crab

I assume that you're talking about the alkalinity solution. My fix for the solution hardening at the end of the tube was to mount the ATO tube on top of the alkalinity one and slightly back. Whenever the ATO kicks in it rinses the end of the Alk one.

I use my ato to flush my auto feeder food supply into the return pump, so not really an options.

Thanks though...