|
|
|
#1
10-29-2005, 06:40 AM
|
|||||
|
|||||
silicon question
ok so befor i was smart and read before i acted i used some bathroom silicon to re attatch the black trim on the topand bottom of an old aquarium. is it still safe to use this aquarium as a sump? the water shouldent really even come close to the top but i duno? can i scrape the silicone off and use ge I? or just leave it?? and will the silicone i put on the bottom leech throught the other silicone and effect my tank (prolly not but just checking) will this silicone even effet this bcause of the little to no contact??
thanks scott 
|
|
#2
10-29-2005, 04:54 PM
|
|||||
|
|||||
|
personaly I would scrape as much of it off as you can and clean it up, then re silicone it.
Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive.
|
|
#3
11-02-2005, 12:05 AM
|
|||||
|
|||||
|
yup....
Dont take the chance........redo it.
__________________
Richard _______________________________________ My wife believed me when I told her it was only going to cost about $500.00. that was over two years ago and I'm still grounded..... 
|
|
#4
11-02-2005, 03:44 AM
|
|||||
|
|||||
|
It's cheap to fix the problem now, scrape it off and redo it....Just think of the cost if it does leech into the system!!!
__________________
500G Mixed Reef  __________________________________ Electrician, Electronics Technician, I can help with any electrical questions you might have!! __________________________________ Kevin
|
Linear Mode
