![]() |
|
#1
|
|||||
|
|||||
![]() I bought a 90 gal off a forum member a year ago and the top brace was cracked. Didnt notice until later.
Tried a few places to get a replacement black trim to no avail. JL suggested that I get a piece of glass cut and silicone it into place. Does anyone have suggestions of how/where to do this in the lower mainland BC? Cheers. Sent from my SM-G900W8 using Tapatalk
__________________
Be Patient. I must keep reminding myself of this. |
#2
|
||||
|
||||
![]() As JL said, get a piece of glass cut, the width, length of your broken centre piece.
Use silicone glue to marry the two pieces. I just bought some glue (not a glue if you believe the propaganda) from can tire. I have not used it yet, so can't give a review. But it is what I would use in your case. Repair the crack with this glue, then repair it again using jL'S suggestion. http://notaglue.com If you need help, pm me |
#3
|
|||||
|
|||||
![]() Its not so much the center brace, Its the whole top trim should probably be replaced.
I'm thinking eurobrace?
__________________
Be Patient. I must keep reminding myself of this. |
#4
|
||||
|
||||
![]() Quote:
Eurobrace would then work for you |
#5
|
|||||
|
|||||
![]() Everyone says "glue" but u need to use pure silicone or it will be a wasted effort. Any glass shop can cut what u need. I wouldn't try to remove old euro....that is a painful process. Just "laminate" new and old together.
__________________
Cheers Gary 604-319-0317 |
#6
|
||||
|
||||
![]() Siliconing glass to plastic is not a good idea. Doesn't hold up very well.
|