Last night I finally found some time to do some finishing touches on the LED build.
Started by placing my lenses on the appropriate led's (at least I hope I picked the right ones
)
Then with my brother's help we drilled and placed the new Plexi splash shield over the entire fixture. Those are the moonlights that are on in this picture.
I really tried to come up with some way to build an apparatus where I could slide the plexi in from one side, kinda like how many of the production units do it, but just couldn't figure out a good way. Thus I went with plastic spacers and stainless screws.
Rather than look at the cut sides of the plexi, I put on aluminum trim all the way around. This should further strengthen the plex from sag (although I doubt 1/4" will sag) and make it less of a lethal weapon when I reach into the tank.
