Quote:
Originally Posted by globaldesigns
I am not having any algae issues whatsoever. Nothing bad like that, just trying to get SPS to color up better. And as you can see with my parameters, nothing is out of line.
Any other thoughts?
|
What if you blow the powerheads
at the rock? Any detritus come flying off there?
Quote:
|
Originally Posted by globaldesigns
Water=1.025
Water Temp=80'C, this doesn't fluctuate that much
PH=8.3
ALK=7-8, based on Zeo... When I had removed the zeolites I raised it to 10-11, but now back down to 8ish
Ca=400
Mg=1350
K=400
Nitrite=0.02
Ammonia=0.15-0.2
Nitrate - I don't know, need to get another kit.
|
Why do you have ammonia and nitrite? What test kits do you use for each test?
I notice you don't have readings for nitrate or phosphate. Provided the "big three" (and K imo) are in check, I have found that NO3 and PO4 are very good at browning out SPS. I find the Salifert kit for nitrate is sufficient and keeping nitrate below 5 ppm is essential for good SPS coloration although I find the best coloration when nitrate is undetectable with a Salifert kit. I use a Merck high sensitivity kit for phosphate as I find anything greater than 0.15 ppm in the water will cause SPS colors to diminish. You need a high sensitivity kit to read these low levels.
Excuse me, but I don't have to read the entire thread. Are you using any sort of phosphate absorbing media? I use GFO on any SPS tanks (and at different times in non-SPS tanks). I really find it makes a huge difference in SPS coloration whether phosphate is problematic or not. Lots of GFO, and little carbon imo. I find huge amounts of carbon will reduce polyp extension on SPS. I use carbon intermittently because of this (just a day or two per week). Some people have mixed reefs with chemically aggressive corals where limited carbon use isn't possible.
Which brings up another point. Many corals are chemically aggressive; like leathers, GSP, Zoas, and Palys. The presence of these corals in an SPS system can and will diminish SPS coloration, polyp extension, and growth. Using carbon will help to absorb many chemicals released by corals, but that's a catch 22 as described above. Keeping away from some of the worst chemical fighters is a good plan, or remove them entirely.
Personally, I would ditch the Biopellets (I'm not sold on their claims). I would run GFO in a reactor. Run carbon passively and intermittently if possible. Play around with the use of Zeolites instead of Biopellets, vodka, or any other "raw" carbon dosing. I'm a stickler for reef designed products. I find the use of "raw" chemicals (calcium, sodium bicarbonate, vodka, etc) to be far inferior to reef designed products. I'm a huge fan of balling salts, which are essentially super pure raw chemicals designed for reefs with some interesting chemical engineering and secret ingredients.
HTH.