Quote:
Originally Posted by whatcaneyedo
How much clearance do you have above the water level in your sump?
I think the big issue that the instructions want you to avoid is having too much back pressure after the gate valve because that would make it impossible to set the internal water level where it needs to be... Try setting it up the way you want and see if it works. If you find that even with the gate valve wide open you cant get the water level in the skimmer low enough you will know that there is too much back pressure because its submersed.
|
Yeah Whatcanyedo, that is the conclusion I came up with too. I figure I'll set up my sump so that I can have a minimum water height of 12", build the skimmer booster seat, and then adjust the water height from there based on skimmer operation. I was screwing around with it a bit and I still think that as long as the outlet water level is below that of the skimmer chamber I should probably be ok.
Quote:
Originally Posted by asmodeus
the water level isn't going to matter with a beckett.
|
Asmodeus, ha haa ha, please elaborate.