Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Tips and Tricks

 
 
Thread Tools Display Modes
  #1  
Old 05-05-2008, 02:22 AM
Myka's Avatar
Myka Myka is offline
Moderator
 
Join Date: Mar 2004
Location: Saskatoon, SK.
Posts: 11,268
Myka will become famous soon enough
Default Livestock Shipping How-To w/ Pics!

Ok, so it took me awhile, but here it is finally...

Alright, so maybe we only want to send a bag or two, and don't want to use one of those big and expensive to ship styrofoam fish boxes. So, we make our own!

Start with some 1" sheets of styrofoam. You can often find them for free if you go to places that sell appliances, office furniture or even cabinets and such as the sheets are part of the packaging. If you can't find any for free you can find some in building supply stores usually in the laminate floor section or rigid insulation section.






Cut it all up (I just use a steak knife) so that it lines the box tightly, including a lid.






Since a DIY styro box isn't water tight, Put a garbage bag in the box.




Add a layer of styrofoam packing peanuts.




Now it's time to bag up some critters! I double bag all bags, and put a layer of newspaper between the bags to prevent the critters from seeing eachother, or in the case of corals it prevents them from poking holes in the bag.

Start by getting a square piece of newspaper that is a couple inches bigger than the bag's width.




Fold it in half, and then on each end you fold it over so that it is just a tad smaller than the bag's width.




Put the folded newspaper into a bag, open it up, and put a second bag into the newspaper.




If you're shipping fish, just plop them in. If you fill the bag to the top of the newspaper you should be able to put up to a 4" fish in there ok...depending on the shape of the fish. A 4" wrasse sure, but not a 4" Tang. Fish ship better with oxygen in the bag instead of air, so it's a good idea if you have it available. Sometimes fish stores will allow you to use their oxygen.

If you're shipping corals, you need to prep them. If the coral is a branching type, or frags on a plug, then cut a disk out of the styrofoam sheet, poke a hole in the centre, and insert the frag plug or the stem. If it's possible use an elastic band to secure it. In the case of clams, brain corals, goniopora, non-branching euphyllia, bubble corals, etc that you can't attach to a disk, then just put them in the bottom with no disk. I like to make the disk almost as big as the bag so that it doesn't move around in the bag too much.

Here's a Monti frag on a frag plug inserted into a hole in the disk. It fits VERY snugly so it won't fall out:




Here's a Candy Cane who's skeleton is inserted into the disk (also very snugly) and an elastic band holding it, just in case.




Close the bag up, and put a double elastic on it wrapping it as tight as you can, then fold the end over and wrap some more. The bag should be TIGHT with air.

This one shows the disk with a coral hanging under it:




Put the bag into your box being sure that there is at least one layer of peanuts under the bag, and lots all around it. There should be enough that so that the bag will not move around. It's not a worry if there are no peanuts on the top because the heat pack will be there warming the air up anyway.




Close the garbage bag with a knot, and tuck the knot in the side of the box so that it's not between the lid and the fish bags.
__________________
~ Mindy

SPS fanatic.


Last edited by Myka; 05-05-2008 at 05:27 AM. Reason: To add more thoughts...
  #2  
Old 05-05-2008, 02:22 AM
Myka's Avatar
Myka Myka is offline
Moderator
 
Join Date: Mar 2004
Location: Saskatoon, SK.
Posts: 11,268
Myka will become famous soon enough
Default

Get a heat pack. I like these ones (available for $1 at J&L Aquatics).




Read the directions on the back of the heat pack. Different brands have different instructions!!!

In this case, this pack heats up as soon as the plastic wrap is removed and the pack is exposed to air. It doesn't need to be shaken or mashed up or anything. This heat pack had red stripes on one side, and the red stripes need to be facing the critters. I loosely wrap a layer of newspaper around the pack keeping attention which direction the red stripes are, and tape it to the inside of the lid. You can skip the newspaper if you want, but I find sometimes the heat packs fall off the lid if they aren't wrapped in newspaper.




Put the lid on the styro box.




Close the cardboard box, and tape it up real well on all edges. Put the address and phone number on at least two sides, and put LIVE FISH (even if it's coral...a lot of people don't understand "coral" can die) on every side along with a big arrow for the right direction up. I also like to put a note on the top "Please call upon arrival".




Now, maybe you're shipping a few bags...so you are using one of the styrofoam fish boxes.




You can cram as many bags in these as you can fit, but be sure to keep fish bags upright so they have enough room to swim. Any bags that have styrofoam disks need to be upright as well. I like to put a layer of packing peanuts on the bottom to keep the water as well insluated as possible.




Fill any void space with packing peanuts. I ran out of packing peanuts. You need to fill the box all the way up!




Tape the newspaper wrapped heat pack (or two) to the lid.




Put the lid on the box, and run a ring of packing or duct tape all along where the lid meets the box (I should have got a picture of this). This way if the bags leak, and the box is turned upside down the water won't leak out of the box. Put the styro box into the cardboard box.




Tape 'er up real good, and write what you need to write (as above).







So that's it! Feel free to suggest slight changes if you'd like.

Also, feel free to send me from frags to practise your shipping!!!
__________________
~ Mindy

SPS fanatic.


Last edited by Myka; 05-05-2008 at 05:31 AM.
  #3  
Old 05-05-2008, 02:38 AM
CLINT CLINT is offline
Member
 
Join Date: Aug 2006
Location: surrey
Posts: 182
CLINT is on a distinguished road
Default

Thats great a lot of people are intimidated by shipping maybe this will help out.The pictures make it very easy to understand.Thanks for all your hard work.Clint
  #4  
Old 05-05-2008, 02:39 AM
banditpowdercoat's Avatar
banditpowdercoat banditpowdercoat is offline
Member
 
Join Date: Oct 2007
Location: 100 mile hse BC
Posts: 2,568
banditpowdercoat is on a distinguished road
Default

Awesome. Ive asked alot of people if they shop frags, but most didnt know how. This needs to be a sticky
__________________
Dan Pesonen


Umm, a tank or 5
  #5  
Old 05-05-2008, 03:08 AM
Pan's Avatar
Pan Pan is offline
Member
 
Join Date: Feb 2006
Location: Didsbury
Posts: 1,137
Pan is on a distinguished road
Default

Nice packing job....

Nice nail color too.. ;0)
__________________
I once had a Big tank...I now have two Huskies and a coyote



  #6  
Old 05-05-2008, 03:28 AM
wickedfrags's Avatar
wickedfrags wickedfrags is offline
Member
 
Join Date: May 2007
Location: Mississauga
Posts: 1,319
wickedfrags is on a distinguished road
Default

Excellent information. Also, for those considering shipping fish, don't forget to fill the bag with oxygen before you tie it.
__________________
I'm out.
  #7  
Old 05-05-2008, 03:31 AM
banditpowdercoat's Avatar
banditpowdercoat banditpowdercoat is offline
Member
 
Join Date: Oct 2007
Location: 100 mile hse BC
Posts: 2,568
banditpowdercoat is on a distinguished road
Default

What if one doesn't have O2?
__________________
Dan Pesonen


Umm, a tank or 5
  #8  
Old 05-05-2008, 04:16 AM
Lance's Avatar
Lance Lance is offline
Member
 
Join Date: Feb 2008
Location: Powell River, B.C.
Posts: 3,572
Lance is on a distinguished road
Default

Well Done, Myka.
  #9  
Old 05-05-2008, 05:09 AM
Atomikk's Avatar
Atomikk Atomikk is offline
Member
 
Join Date: Apr 2006
Location: Mississauga, On
Posts: 285
Atomikk is on a distinguished road
Default

Sometimes those styro discs don't have to be that big. It all depends on the size of the coral/frag. Otherwise, a very good ilustration on how to ship livestock.
__________________
  #10  
Old 05-05-2008, 05:13 AM
banditpowdercoat's Avatar
banditpowdercoat banditpowdercoat is offline
Member
 
Join Date: Oct 2007
Location: 100 mile hse BC
Posts: 2,568
banditpowdercoat is on a distinguished road
Default

Ya, Styro disks great Idea. My Xenia was upside down at the bottom of the bag when I got it from Greyhound. Didnt survive
__________________
Dan Pesonen


Umm, a tank or 5
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 02:54 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.