|
|
|
|
|
#1
11-17-2007, 08:59 PM
|
||||
|
||||
Quote:
i access mine from the explorer bar by typing 10.1.1.1 what type of adsl router do you have. 
|
|
#3
11-17-2007, 09:01 PM
|
||||
|
||||
|
Matthias i have a duel conductivity/redox card. would be good if something was marked on the card to tell which is the conductivity or redox meter.
Tip for anyone with dual conductivity/redox sensor: the bottom sensor is the conductivity and the top is the redox. Last edited by reef; 11-17-2007 at 09:43 PM.
|
|
#4
11-17-2007, 09:35 PM
|
||||
|
||||
|
Matthias,
re the flow rate of the pumps. do they adjust the speed as per dosing programme or do they just dose all at the same rate. i set different flows for the pumps and it look like they all dose at the same speed. Last edited by reef; 11-17-2007 at 09:42 PM.
|
|
#5
11-17-2007, 09:46 PM
|
||||
|
||||
|
Quote:
You have to find out the ssid by using the lynksys software or maybe putting 10.1.1.1 on the explorer bar. Last edited by reef; 11-18-2007 at 01:02 AM.
|
|
#7
11-18-2007, 08:22 AM
|
||||
|
||||
|
@reef:
The dosing pumps have a flow rate of approx. 60ml/min. Due to tolerances of the motor or the pump it is possible that a pump has a different flow rate. You can correct the parameter "flow-rate" if needed. This parameter influences the calculated "on-time", not the speed. Please see manual chapter "dosing pumps". Error1: while the first seconds of boot-up ProfiLux can't communicate with View - than Error 1 is displayed. After boot-up is completed View starts to work - no problem combo-card: there is no place for a print on the rear plate. But with each card is a manual shipped. This manual describes which functions the BNC-plugs have. @teejay: You can find the SSID also on your PC under "properties" of your network-connection.
|
Hybrid Mode
