Scribing plywood (Now with more RAD) - Page 4

lastlight · #31 08-30-2011, 07:16 PM

my experience with actual blades is i end up shredding the good side somehow all the time. tape or not. I'll bet my blade is old and cheap tho.

kien · #32 08-30-2011, 07:45 PM

Or you could just leave the stand as it is and just paint it.

parkinsn · #33 08-30-2011, 07:50 PM

Or just follow your track record.... Sell it and start over

kien · #34 08-30-2011, 07:58 PM

Quote:

Originally Posted by parkinsn

Or just follow your track record.... Sell it and start over

The Grizz · #35 08-30-2011, 08:01 PM

Quote:

Originally Posted by parkinsn

Or just follow your track record.... Sell it and start over

I think this one is a keeper with it built into the walls and all of Bretts hard work. I cant wait to see it all done, got to see the tank before the walls and finishing work and I must say its a BEAST!

parkinsn · #36 08-30-2011, 08:08 PM

Quote:

Originally Posted by The Grizz

I think this one is a keeper with it built into the walls and all of Bretts hard work. I cant wait to see it all done, got to see the tank before the walls and finishing work and I must say its a BEAST!

I own a hammer, I could help him take those walls down to get it out

lastlight · #37 08-30-2011, 08:17 PM

ok I'm now at the point where on a whim I could go either way. The decision will likely be spur-of-the-moment and at 2am when I'm not fit to decide. So have your fun you MFs =)

And no a wall cannot contain my builds. The last 400 was in a wall for a very short time before I myself took a sledge to it lol. Looking back now... thank frag because I think it looks pretty hideous lol.

The Grizz · #38 08-30-2011, 08:20 PM

Well in that case........I will be standing by with my sledge hammer in hand waiting for the call for destruction

parkinsn · #39 08-30-2011, 08:23 PM

Quote:

Originally Posted by lastlight

ok I'm now at the point where on a whim I could go either way. The decision will likely be spur-of-the-moment and at 2am when I'm not fit to decide. So have your fun you MFs =)

Well if your going to leave it open to debate.... Are you sure you are fit to decide this at any time of day?

lastlight · #40 08-30-2011, 10:54 PM

You must BELIEVE in the power of the SCRIBE!!!

In summary:

Going with the grain is FULL-ON-BAWLS. Removes in one strip with a much sharper edge. Heck it even sliced easier and took half the time =)

And plywood-on-end isn't even that bad for a really quick attempt.

GAME ON.