|
|
|
#21
09-02-2010, 05:57 AM
|
|||||
|
|||||
When you guys say you used pine, maple, birch or whatever...do you mean plywood with a veneer? That seems to be the nicest stuff I see at home depot etc...
|
|
#22
09-02-2010, 06:45 AM
|
||||
|
||||
|
Sort of my stand is done in 3/4 " ply on top of framing then maple ply 1/2" it's done with complete trim all around and my corners are done in three pieces with the center piece a rope trim it's the only wood on there I'm not sure of and it creates a rounded corner. at the top of the stand is my customized crown moulding(maple) the corners run up to and have been cut to fit, a thin strip of maple is ran down to fill in the top of crown moulding where the gap is creating a flat surface again
 now I'm ready to do my round corners again up to the canopy hope this makes sense I'll post a pic tomorrow I took some pics once I started staining but basically I didn't want a hollow stand so I used regular 3/4"plywood then my maple it's strong and cheap considering it's never seen anyways all Finish done with brads and finishing nails
__________________
........
|
Linear Mode
