|
|
|
#21
03-13-2003, 11:03 PM
|
||||
|
||||
Send it to me, I can run it on my tank and take pictures for you, ... for a small price... ( Like.. its MINE)
Good job that does look awesome. What did you use for the seals? The red stuff. 
|
|
#23
03-15-2003, 05:20 PM
|
||||
|
||||
|
What are the Seals made out of? did they come as is or did you have to cut them?
|
|
#24
03-15-2003, 05:50 PM
|
||||
|
||||
|
I can't remember the name of the stuff, it's silicone basicaly. Got it in a roll of about 3'x6' and cut them to size. It's 1/4" thick and seals very well, easy to cut and it was fee from a buddy. Apparently it's supposed to be extremly expensive, $200+ for the roll i got. :shock:
Clinton
|
|
#25
03-15-2003, 05:55 PM
|
||||
|
||||
|
lol That figures, I like it.
I am going to build a unit, ... skimmer/Ca Reactor, two towers, I think I will just use O rings though.... I'm going to Home Depot today to get some ideas though, have to see.
|
|
#27
03-15-2003, 09:31 PM
|
||||
|
||||
|
Thanks I will send you a PM when I need them.
|
|
#28
03-18-2003, 05:53 PM
|
||||
|
||||
|
More ?'s
 I can't see it in any of your pictures, but, what did you end up using for the air control valve on the beckett housing? I just finished the injector housing for mine and now just have to find an air valve for it. I guess it shouldn't matter if the valve is in the lid of the housing or in the side of the tube. I looked at a Bullet skimmer yesterday and I think it was in the lid. Also I'm not sure if I am going to use an injector pipe in the first reaction chamber or the swirl injector design. The swirl design looks fancier.  ops:
|
|
#29
03-18-2003, 08:51 PM
|
||||
|
||||
|
I ended up using a 3/8 ball valve from the beckett section at Revy, opps i mean Rona. 8) I put it in the lid as well that way it's not hangging in the way. I think the swirl idea would work jusrt as well, not sure if it looks fancier. Unless you think the white ABS plumbing is fancy.
  Clinton
|
Linear Mode
