![]() |
#11
|
|||||
|
|||||
![]() Well how about a postive note the quinster. Looks awesome buddy, Now how about helping me get a new sump .
mike
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. |
#12
|
|||||
|
|||||
![]() Quote:
![]() IMO, the satisfaction of DIY project is DIY. Tak |
#13
|
|||||
|
|||||
![]() danny zubot : don't know how a needle wheel pump would work on these types of skimmers...never had one running on this application...maybe someone could shed some light on this...
takphan : thanks for the comments...like to try if I can
__________________
Getten Outta Dodge |
#14
|
|||||
|
|||||
![]() I think I might have to get my friend's needle wheel and try it out. I think there would be less adjusting to do if it did work.
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041 |
#15
|
|||||
|
|||||
![]() Danny, are you going to use a needle wheel pump to drive a Beckett or are you going to add one as a recirculation pump on the skimmer?
I doubt it would drive a Beckett very well, and a recirculating pump on a beckett isn't really needed (though it should boost performance).
__________________
32"x32"x20" Cube-ish tank |
#16
|
|||||
|
|||||
![]() Tried another change...hooked up a 1 1/2" clear down tube now...looks cool, and bubbles seem to flow better and smaller.
![]()
__________________
Getten Outta Dodge |