LED Intensity

[StirCrazy]

Originally Posted by Aquattro

dude, get this out of my thread!!

what your against informational posts now .

simple answer. yes you can do it but you will never be able to increase the intensity unless you drop the lights. but you have several options. the higher you lift your lights the tighter of a vewing angle you can use which gives you more par/intensity as a specific distance and better blending as your farther away. if this is the way you are leaning I would sugest going with something like the 50 watt LED cannons you could have a blue and white right against each other for perfect blending and you could probably recess them into cealing fixtures using optice to controld how big the spread is. I think that would be the coolest setup. no visable lights, just pots mounted into the celing and yet a tank that is still customizable in light color and intensity. you could use electronic dimmers/controlers that mount into a light switch housing and are controled by your computer. now quite trying to drag out of me what I have been working on

Steve

[Delphinus]

What you should do is try placing them in various different spots and seeing what you like best.

[Aquattro]

Originally Posted by muck

Ask sbux for a V.I.P. discount card...

shut.up!

[jorjef]

Originally Posted by Aquattro

kinda my plan as well. I"ll start with 3 and see how that goes. Problem I have is that the tank may suffer before I can afford to buy more.

Just leave your existing lights in place, when the new ones arrive just get a bunch of people together to do a mock up and hold the lights over the tank for you as you sit back say "okay a little to the left, now up..no no the other up, you know down" All the time adjusting intensity to see how you like it. If you decide you need more units the original light is still there until the other unit arrives and swap out then.

[Aquattro]

Originally Posted by jorjef

Just leave your existing lights in place, when the new ones arrive just get a bunch of people together to do a mock up and hold the lights over the tank for you as you sit back say "okay a little to the left, now up..no no the other up, you know down" All the time adjusting intensity to see how you like it. If you decide you need more units the original light is still there until the other unit arrives and swap out then.

Oh, absolutely. I currently have a canopy that can just lift off. It will go to the side until I'm sure the new lights can maintain color. If not, they go back on until I can buy more units.

But I'll try to run closer to 80%+ on the whites to try and keep intensity while raising high enough to keep coverage.

[DanG]

My lights are hung under my canopy pretty much sitting on the tank brace, so mine are pretty close to the surface, which makes them super bright. This in turn has caused me to have the whites about 40% and the blues close to 90.

If I had a way to have them up higher, I'd probably run them higher just to get the same level of brightness.

[troni]

Holy look like night time in there? What's your white to blue ratio?