What Salt do you use?

[Chin_Lee]

Jason
If you are measuring the basics each time, i don't see any real benefit over the use of one of the cheaper salts. I also measure the basics each time to determine if there are any deficiencies. I then use the supplement calculators to bump it up accordingly. After I add the supplements, i don't re-measure and its pumped into the sump during the water change.

To save time, I've written up on the wall above my 60g water tanks on how much of each supplement to add to increase 10ppm in 60g of water. So if I'm 100ppm short on Mg, I multiply that number by 10, measure that amount of Mg, and dump it into the water. (2 minutes maximum for bumping up one supplement)

On $40-50 difference per bucket in salt prices, thats enough Mg/Ca from Mr. ChemMaster to boost the Mg/Ca for 20-30 buckets of salt (no i'm not getting any commission on sales i just feel that his product is very good quality stuff).

In addition, $40-50 for 5 minutes of your time is really not that bad of a trade off. I know I don't even make close to $40 in five minutes even on overtime wages (that $9-10 per minute). On the other hand, has Tropic Marin made an additional $40-50 for the 5 minutes that you've saved?

Since we may have thousands invested in livestock and taking into consideration the number of bad batches of salt by some bigger salt manufacturers, i strongly believe that testing the alk/mg/ca is always required on all salts regardless how much we've paid for it. I guess my point is:
if we are testing once already, and to save $40-50, why not add the supplements (if required and especially if you have a quick reference system set up already).

If I were to pay an extra $40-50 per bucket of salt, I would expect the following from the salt manufacturer:
- no need to measure the basics
- guaranteed %min. on the good elements
- guarantted %max. on the bad elements
- livestock replacement guarantee if any of the % min/max analysis was not met and the use of the salt caused the death of the livestock(s)
Otherwise, i'll take that $40-50 to spend on something else with this hobby.

Originally Posted by Jason McK

Don't you feel in the long run with all the testing and addition of supplements and your time it ends up costing you more.

I was of the same mind set as you, until I started to read about the fillers that are in the salts that may boost measures numbers like CA or ALK but have no benefit to corals. I also took a close look at the amount of time I spend getting my water change water perfect. 3 or 4 tests for Mg, ALK and CA while adjusting between each.
What prompted this thread was a need to find out what everyone else was doing (It was successful) but the reason I was wondering was because despite my best I still had a display tank that was reading 4KH. This was do to the inconsistency of the salt I was using. So I'm assuming now there is no way I can read my make up water 2 or 3 times and if it's good Assume it will always be good.
I'm on Tropic Marin now and will measure the 3 basics each time I make a new batch but if I'm forced to add any supplements I will return to a cheaper salt.

[Jason McK]

Very good system Chin. I guess I don't trust myself enough to add a perscribed dose of something without measureing again. I'm wrong too often.

[untamed]

I'm getting 7.4dKH on the batch of Ocean Pure Pro that is in the mixer right now. I also checked the salinity, and I'm a bit low. I assume that if I add additional salt, I'll get some rise in this number.

It's made me realize that I can't just put 50 gallons of water and 1 bag of salt and expect the salinity to be correct. I never accurately calibrated the 50 gallon mark on my mixer....maybe it's not exactly right.

[danny zubot]

I assume that if I add additional salt, I'll get some rise in this number.

Maybe, but I didn't get any rise when I did my change last weekend after I corrected my salinity. It still read 7.4.