|
|
|
|
|
#1
12-25-2006, 12:59 PM
|
|||||
|
|||||
Tony,
Ok, working off some reading I've done on this topic - not first hand (I prefer coil based denitrators myself). Sounds like your through-put is way too fast, crank it WAY down until you start seeing effluent output with 0 nitrite / 0 nitrate (or get stunk outta the house - that'd indicate way too slow). Once you get that 0/0 effluent then start bringing up the drip rate slowly. Definitely check that mag pump you're using for recirc... Although that kicks your cycle back to day 1 again (introduction of too much o2 - supposed to be a low o2 environment), if it's not working up to snuff - the lack of recirc could be causing some problems. since i'll never find the link again - good rc thread: http://reefcentral.com/forums/showth...hreadid=752497 Last edited by AndyL; 12-25-2006 at 01:06 PM. 
|
|
#2
12-25-2006, 07:26 PM
|
|||||
|
|||||
|
Oh yeah, one thing is, the effluent has never had any kind of sulfurous scent to it whatsoever. Isn't that odd? I think it has be indicating something's not right here.
Yeah, maybe 1 to 2 drops per second is too fast for the volume. I'm firmly convinced that this is not working and not going to work given an indefinite amount of time -- something has to change on it first.
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee!
|
|
#3
12-25-2006, 09:51 PM
|
|||||
|
|||||
|
Tony do you have a pic of the reactor I would like to look at it for a sec..
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think.
|
Hybrid Mode
