400 gallon project

[untamed]

It would seem that I neglected to explain my water change system. As it is difficult to show in photographs (and all the Herbie valves create visual confusion), here is a schematic that explains it.

[Chin_Lee]

Very very well done. I am truly impressed by your foresight and your layout and planning. Love your journal as well with the room layout, then the containers in, then the walls, electrial etc etc.

You mentioned you need some modification to your gate valves on your overflow. Can you elaborate?

Where did you get the 90 degree metal brackets for your front and side ramps?

I see an air duct in ceiling - does this goes into your house's furnace air return? If so, any consideration to venting the air directly out of the house? In my setup, I am looking to install a dehumistat on my fan to vent moist air directly out of the house when the relative humidity gets too high.

great job.

[untamed]

Originally Posted by Chin_Lee

You mentioned you need some modification to your gate valves on your overflow. Can you elaborate?

Where did you get the 90 degree metal brackets for your front and side ramps?

I see an air duct in ceiling - does this goes into your house's furnace air return? If so, any consideration to venting the air directly out of the house? In my setup, I am looking to install a dehumistat on my fan to vent moist air directly out of the house when the relative humidity gets too high.

great job.

The photo I posted shows 3/4" gate valves. It turned out that these couldn't carry enough of the flow. I needed the 1.5" outlet to be restricted...but not that much. I've since replaced these with 1.5", which I can dial back as much as required. I tried to save some money, and it cost me more in the long run. Anyone looking for some 3/4" gate valves?

The 90 degree brackets. That project is in my garage. Still top secret that one. The brackets were fabricated by a local metal shop. Cheap and simple.

I should have mentioned the ceiling duct. That vents directly to the outside. I may run it on a humidistat and/or thermostat...or I just might run it all the time. We'll see.

[untamed]

Originally Posted by LostMind

Wow, very nicely done. So when you inviting all the local reefers over to ooh and ahh ? :P

Originally Posted by vanreefer

Looking good man I am awaiting the open house to view the final product

I'm figuring summer BBQ at my place. Until then, there won't be too much to see.

[more1020]

Very nice tank and neat setup!

May I ask you a question? I just saw you are using two white plastic buckets for your skimmer and as a sump. What are they actually? And how big are they?

Thanks!

[untamed]

Originally Posted by more1020

Very nice tank and neat setup!

May I ask you a question? I just saw you are using two white plastic buckets for your skimmer and as a sump. What are they actually? And how big are they?

Thanks!

The skimmer is a G6. It may be cheap, but I wouldn't call it a plastic bucket!

There are two sumps. Both are PE plastic. I purchased these from a tank manufacturer and they were shipped from Florida. The larger one is 120 gallons (48Lx24Wx24H)...the smaller is 60 gallons (36Lx20Wx20H). The same shipment also brought the 50 gallon mixer and the 100 gallon RO cylindrical tanks.

I would have been nice to do the sumps out of acrylic, but there was just too much money to be saved doing them in PE since I had to purchase/ship the cylindrical tanks no matter what.