![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||||
|
|||||
![]() I am currently running a profilux standalone 3pump doser and it is about a year old. For some strange reason the 3rd pump is now constantly running and not stopping. I have disconnected the doser several times but each time I reconnected the power the same doser would be running. I have checked the settings and there are no changes and the other two dosers are working accurately. This had just started while I was cleaning out the sump... The doser is sitting far enough away from any possible water spills etc... and I have checked all the lines and tubes for each doser...
Has anyone experienced this and any idea to fix it? Thanks Wayne |
#2
|
|||||
|
|||||
![]() pm replied to.
|
#3
|
||||
|
||||
![]() this only happens after a water damage:
either the front board (mostly the buttons) got wet or the small board inside with the western sockets got wet in some cases it helps to clean the boards, but mostly there is too much corrosion after a water damage and you can't be sure that the doser will work in future without problems - in my opinion a too high risk both parts are available as spare parts please contact your retailer for further details |
#4
|
|||||
|
|||||
![]() Quote:
Again, the unit was not near any water nor did it get splashed... do you recommend me opening it and have a look anyways? Thanks Wayne |
#5
|
|||||
|
|||||
![]() Yes - please refer to our instructions in the pm.
![]() If in dout on opening please send very clear photos of the exposed pins of the connector cable to the front board. |
![]() |
Thread Tools | |
Display Modes | |
|
|