![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
![]() tried a chisel and hammer, but whoa thats hard!!!
|
#2
|
|||||
|
|||||
![]() If it's been properly set and laid then you'll need an air chisel at the very least or most likely a small jack hammer. Have you considered just laying the new floor on top of the old tile if it's still in good condition?
|
#3
|
|||||
|
|||||
![]() You have a tile floor in your reef?
|
#4
|
|||||
|
|||||
![]() +1 to this
__________________
My Other Car is a Reef Tank |
#5
|
|||||
|
|||||
![]() 5-10lb "sister" sledge?
![]()
__________________
260g mixed reef, 105g sump, water blaster 7000 return, Bubble King SM 300 skimmer, Aqua Controller Jr, 4 radions, 3 Tunze 6055s,1 tunze 6065, 2 Vortech MP40s, Vortech MP20, Tunze ATO, GHL SA2 doser, 2 TLF reactors (1 carbon, 1 rowa). http://www.canreef.com/vbulletin/showthread.php?t=50034 . Tank Video here http://www.vimeo.com/2304609 and here http://www.vimeo.com/16591694 |
#6
|
||||
|
||||
![]() use a heavyduty ice scraper slam it underneath along the floor and they should pop hard on the arms but a work out is always good
|
#7
|
|||||
|
|||||
![]() rent a hilti electric jack hammer and tell them what your doing so they give you the right tip.
Don't lay tile over old tile, not only is there a bonding problem but you double the weight on the floor which will lead to excessive deflection and cracked or popped tiles. One thing you never mentioned was which type of subfloor, is it concreat or is it a wood subfloor. Steve
__________________
![]() Some strive to be perfect.... I just strive. |
#8
|
|||||
|
|||||
![]() There is a vibrating 'tile peeling' piece of machinery called a tile stripper, I believe. I used one to remove a couple hundred square feet of tile last year...
__________________
Calvin --- Planning a 29 gallon mixed reef... |
#9
|
|||||
|
|||||
![]() Hire a contractor,lol. Just kidding. The ice scapper works but must be sharp. and yes there is a tool called a tile stripper ( and you don't have to feed it loonies or toonies). Just have to make sure you stay under the tile and not down into the sub floor material and they will pop off, low angle of attack.
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build |
#10
|
|||||
|
|||||
![]() Slam the floor a couple times with a sledge hammer. The vibration should cause surrounding tiles to pop loose. Repeat.
|
![]() |
Thread Tools | |
Display Modes | |
|
|