![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
#21
|
||||
|
||||
![]() On my JBJ12 microbubbles was either low water level, or one time the hose from the pump up to the outlet had a small crack in it where air was sucked in by the passing water.
__________________
Single System Setup: 210G SPS reef, 225G FOWLR, 72G water change, 50G frag, 120G sump. I promise a journal at some point! (anyone need some coral frags? I likely always have stuff that is frag-ready) |
#22
|
||||
|
||||
![]() awesome tahnks for the advice perhaps my hose is cracked at the moment. May I ask if you run a skimmer and if so where is it located? which camber if that is it sits in the back
|
#23
|
||||
|
||||
![]() Yep skimmer -- the Oceanic one, works great for this tank (much better than it does in the oceanic BC 14
![]() All in the photo: Chamber 1: heater, bag of GFO, bag of Carbon Chamber 2: skimmer Chamber 3: chaeto (on a "tray" sitting on top of the pump) Output: Hydor FLO rotating deflector Water level in the back kept at the chamber 2->3 overflow level -- which is good for the chaeto and seems ideal for the skimmer... skimmer makes very thick buildup, not much liquid, which is ideal for such a small system. ![]()
__________________
Single System Setup: 210G SPS reef, 225G FOWLR, 72G water change, 50G frag, 120G sump. I promise a journal at some point! (anyone need some coral frags? I likely always have stuff that is frag-ready) |
#24
|
||||
|
||||
![]() Thanks that helped alot I tried it in C1 but its a bugger to deal with. I am doing my weekly change out tuesday, so I will swap er then haha.
I do have a question for anyone out there who uses Chillers on nano tanks, my tank at night sits at about 79.2 F recently I have discovered, that with the warmer weather if I do not take percautions to close my room door, the tank may get as high as 85.6 F. Im a little worried about this and would like to know the best solution to correct it, I am planning on an LED upgrade with stunnerpros from Modular but until then I need a solution. Thanks for the help everyone, and hope to hear some responses soon. |
#25
|
||||
|
||||
![]() If you are prepared to spend few hundreds on chiller then go for it, imo it's not worth it for nano tanks. Once you upgrade to LEDs it will help a bit with the temp. I would just move your tank or something.
|
#26
|
||||
|
||||
![]() Hey all, update on the tank staus. It has been going swimmingly hahaha but i have list a few corals along the way. Most recently a torch coral. The real reason I'm posting is I need help adding in a new fish to the tank. I have 3 sexy shrimp 2 females 1 male and the male ia quite small. I am concerned about what fish to add that would get along with thr sexy shrimp and the single firefish. In the tank. Please let me know.
|
#27
|
||||
|
||||
![]() I have a question. what is the best way to plot out a good colour scheme for my coral layout and also, how would I add extra sand/crushedcoral (if sand is too light with my pumps) and possibly attempt to rescape a bit more? suggestions very appreciated.
|
![]() |
Thread Tools | |
Display Modes | |
|
|