![]() |
|
#1
|
||||
|
||||
![]() Hey everyone. Does anyone have a tank set up in their furnace room?. I currently have my set up built into the wall but on my access side its my furnace room. Im a little worried if sw will corrode or be hazardous to anything in the furnace room?
Thanks. |
#2
|
|||||
|
|||||
![]() Hard to say without a tad more detail, such as, is it the basement, photos? As a good rule of thumb, a little ventilation goes a long way! I have plans for a basement sump which will be in the general vicinity of my furnace. Furnace or no, I'll need to think about ventilation, humidity, etc.
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build ![]() |
#3
|
||||
|
||||
![]() I will get some photos. Its in the basement, furnace, air exchanger and electric box and water heater in there. I dont have a door on the room. Virtually everything is at opposite end of the tank and sump
|
#4
|
|||||
|
|||||
![]() I'm no HVAC expert, but if you have an air exchanger you should be ok with respect to ventilation. Still, a bit of additional ventilation in the basement to keep the humidity down may be a good idea. If the components you're concerned about are a good distance away, then a bit of salty humidity at the other end of the room shouldn't be a huge concern. But I'm just guessing here, hard to gauge without seeing the set up. Age of your home & overall air tightness will determine if additional ventilation is required. Saskatchewan winters are typically pretty dry (air wise). The house may actually benefit from a bit more humidity.
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build ![]() Last edited by mike31154; 12-19-2014 at 03:40 AM. |
#5
|
||||
|
||||
![]() Thank you for the replies!!
|
#6
|
||||
|
||||
![]() Im a heating guy.... I wouldn't worry so much about your furnace as I would your electrical panel..... my tank has rusted out my fireplace louves 15 feet away in 2 years.
I'd install a bath fan or someth I ng if possible and put it on a humidistat or timer to clear out the excess humidity. No matter how you look at it salt or not water water will produce humidity which is bad for electrical components- your panel and all the wiring in the furnace The duct work will rust over time as well. Get some type of ventilation in the room. What type of furnace and hwt do you have? If not direct vent you can't exhaust air out as a negative pressure will draw products of combustion into your house. PM me for further questions or details.
__________________
250G DD LED SPS R.I.P. 180G LED SPS 80"x36". 300G custom build Owner of Mountain Ridge Heating and Gas Class A gas fitter, HVAC Last edited by e46er; 12-19-2014 at 04:06 AM. |
![]() |
Thread Tools | |
Display Modes | |
|
|