Ghl Profilux Discussion And Support Thread

[Aqua-Digital]

To go from 3.08 firmware to 4.0 you must do the following

Install firmware version 4.0 first

then

Install software version 4.0

Never do the other way round.

You also can not run version 4.0 software without loading the firmware either

[bullit67]

yah But I goofed and installed the software first as I was having problems with the 3.8 software I need to get the 3.8 version of the software back so I can do the upgrade but I cant find any place to download it

[Aqua-Digital]

CLICK THE CRAB

[bullit67]

Oh man I looked there and did find it but I guess I didnt look close enough because I found it now. I guess I should of put my glasses on sooner

Thanks again

Doug

[Todd]

I am having problems getting my float valves to work. I have two valves on a splitter and the computer recognizes that I have two of them (as when I disconnect them it acts differently). But I cannot get the computer to realize the float is floating (ie tank is full), it will continue to run untill I get a time out alarm.

I have tried it with only one float and no splitter, the other with no splitter, both with the splitter. Plugging one in and resetting the computer then trying - all the same result, it will not recognize when it the valve is floating (ie when to shut off the pump). I recently had one of the valves replaced under warranty (through progressive reef). Both of the valves are clean.

I also tried upgrading to Firmware 4.04 and software 4.0.3.0 hoping that would solve things, no to no avail.

Any suggestions?

[Aqua-Digital]

Hi

Does it work when plugged in independantly

[Todd]

No, it recognizes that only one valve is plugged in, but it will not register that it is 'full' and switch off.

[Patrick1]

What is your delay setting time at?

[Todd]

It was 2 seconds, but I moved it to 0 seconds while I was trying them.

[Aqua-Digital]

Pop it into Spensor at PG