|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
|
Thread Tools | Display Modes |
#91
|
|||||
|
|||||
Best to email me at sales@aqua-digital.com
it is always hard supporting second hand units and we could be going back and forth for a while on the board. |
#92
|
|||||
|
|||||
E-mail Sent
J |
#93
|
|||||
|
|||||
Michael, Just wanted to thank you for your support on my Temperature probe issue. Spencer at Progressive Reef hooked me up with a new probe and all is right in the world now.
Thanks Again Jason |
#94
|
|||||
|
|||||
Glad to be assistance and thanks to Spenser at progressive reef in BC for helping you get up and running.
|
#95
|
|||||
|
|||||
Sorry Michael, Have another one for you
I picked up a new temp probe and it has been working perfectly. Today I added the extention cable to the temp probe. Without the extension temp was reading 79.4 I followed the extension cable instruction as per the latest operator instructions. 1)entered the extension mode without the extesion cable attached (probe was in the tank in the same spot it would be when the cable gets added) 2)press return and wait 3) controller say Change 4) add the extension cable and press return 5) wait and then save My temp was then reading 74.2 in order to correct this I calibrated the sensor with the extension cable and the temp control returned to 79.5 Have I performed the procedure incorrectly? Thanks Jason |
#96
|
|||||
|
|||||
Hi
You need to add the cable first as you found I think from reading your thread Hope all clear now |
#97
|
|||||
|
|||||
Um that is not how the instructions read.
The controller prompts you to change/add the cable J |
#98
|
|||||
|
|||||
I will ask Matthias to change it
|
#99
|
|||||
|
|||||
I assume the Extension mode measures the temp and the resistance in the cable before you add the extension. Then through the mode you tell the unit you just added the extension and it measures again. then calculates the difference and increases the signal voltage to compensate.
OK, I'll wait for Matthias Thanks |
#100
|
|||||
|
|||||
Hi Michael
I have a bit of a problem I was having problems with the software on my lap top so I so I loaded up the new 4.0 version well now I cant connect to the controller it tells me I need a lower version of the software. I can not find any where to download a lower version of the software. thanks for your time Doug |
Thread Tools | |
Display Modes | |
|
|