Reef Plumbing Experts?

[Myka]

Originally Posted by input80

Thank you Mindy, Unfortunately, the return holes in the overflow are already 3/4"; as I believe I went this route because loclines only go up to 3/4"? The pump is a Jebao/Jecod DCT-15000.

Sorry I don't know anything about the Jebao line, and I don't think you'd be able to get a response from them either, but you could try! You're probably ok as long as you run the 1" all the way to the bulkhead (it has 1" output right?). That said, I'm not the manufacturer.

[Ryanerickson]

Run 1" too the tee where they split to either bulkhead. outta the 1" tee use bushings to reduce down to 3/4 run the 3/4 to the bulkheads.after the tee the flow is cut in half no need for 1" all the ways to bulkhead unless there is only one return hole and in that case there's no tee.

[Myka]

Originally Posted by Ryanerickson

Run 1" too the tee where they split to either bulkhead. outta the 1" tee use bushings to reduce down to 3/4 run the 3/4 to the bulkheads.after the tee the flow is cut in half no need for 1" all the ways to bulkhead unless there is only one return hole and in that case there's no tee.

Agreed. I was assuming a single return.

[input80]

I'm not too sure that this belongs under pump specific, as it is not restricted to a pump?