Cutting Thick (1/2") glass

[Chin_Lee]

the one i have didn't spray but had a resevoir tray on the bottom that the blade dips into. same concept. give it a try with something smaller first to the get hang of it. the difficulty with this was the table area is not large enough to cut a large piece of glass - it was only cutting a strip into half. As you near the end of your cut, it will be extremely difficult to keep the two pieces perpendicular to the blade and finisihing with a clean cut through. For a larger piee of glass, you will have to jig a cutting surface table with a lowered area to be flush with the tile saw table height and a fence that's clamped down. hope that makes sense.