![]() |
|
#1
|
|||||
|
|||||
![]() I know some people that use the Seachem products, and I've used the Flourish Nitrogen myself. I couldn't find these products recently, so I ordered NaNO3 from a science company in the US. It's much cheaper than using Flourish.
I've been at 0 ppb on the Hanna ULR Phosphorus kit until today I finally hit 6 ppb (0.006 ppm). Phosphate is easy to increase - just feed the crap out of the fish. Why don't you switch back to normal biopellets? |
#2
|
||||
|
||||
![]() Quote:
Started kalkwasser again recently (still dosing 2 part as well) which may also be contrubing to the elimination of phosphates. Figure maybe dosong a bit of phosphates might get my nitrates a little lower. |
#3
|
|||||
|
|||||
![]() Which checker are you using? The ULR Phosphorus or the Phosphate?
|
#4
|
||||
|
||||
![]() ULR Phosphorus
|
#5
|
|||||
|
|||||
![]() I think if you remove the phosphate reducing agents you're using that will solve the problem.
|
#6
|
||||
|
||||
![]() Only direct phosphate reducer I'm using is the all in one biopellets. When I used regular biopellets in the past nitrates were low but required GFO to get the phosphates down. I'm trying to avoid using GFO separately.
|
#7
|
|||||
|
|||||
![]() ill give you some of my water and you can dose that lol
wish i had that problem of 0ppm nitrate 0ppm phosphate.... soon soon
__________________
Current tank---125 gallon mixed reef 60 gallon sump, Reef octopus nw200 skimmer, Rapid LEDs, Maxspec gyre, Mp10s, Fuge, Biweekly 20% WC, QT everything |
![]() |
Thread Tools | |
Display Modes | |
|
|