DYI Stand Plan, how is this idea?

[intarsiabox]

I've seen one neat rick but haven't tried it myself. You take a small V chisel and make an incision to lift up a piece of the plywood with it where you want to place a finishing nail. Tap the nail in and then add a dap of wood glue on top of the nail and fold the piece of ply wood pack into place. Sand a bit when dry. The nails are completely hidden. Myself I prefer to use screws on the sheeting and then glue a piece of matching wood molding over top of the heads. You can get some really nice molding that really make the stand look like a piece of furniture rather than a plywood box.

[whatcaneyedo]

Here is what I did for my recent upgrade. 2x4 studs, top and bottom plate. 2x6 joists and rim joist. 1/2 oak sheeting for the sides and 5/8 pine for the top. Before applying sheeting to the top I power planed the crowns out of joists and checked everything with a straight edge to ensure that the top would be flat. Framing was assembled with 3" deck screws and sheeting applied with 2-1/4 deck screws (its what I had on hand, they didn't need to be that long). Then I finished everything off with oak baseboard, chair rail, panel moulding, crown moulding and casing. I stained (two coats Mission Oak) and Varathaned (two coats semi gloss) all of the trim laying flat before cutting and fastening (an attempt to avoid run lines and drip marks). The finish trim was installed with brads and a bit of wood glue, I then filled the nail heads with putty. I sort of wish I had made the bottom of the stand a little 'bolder' to mimic the top but other than that I'm pleased with how it turned out.

[Easto]

Looks good.

I was going to stain it, however now I am leaning towards white paint.

[Easto]

Plywood type: I was checking out plywood and I figured between maple, oak, and birch that maple would be the most expensive. However maple was $55 per sheet 3\4", birch was $73, and oak was $79. Should I just go with maple?

[monocus]

shop around on your prices.your birch seems really expensive.i get my birch at rona or windsor for $37 a sheet,mahogany at $50,oak $80.and depends on the type of maple.(all 3/4)again maple does not take stain well

[Easto]

This was at HD. What's the best if we are painting.

[monocus]

doesn;t matter about your top as it will be covered.the sides i use 1/4 mahogany door skins-very tight even grain