LF : 1" pvc and 1 1/2" PVC

[Aquattro]

I get the white fittings. Work good.

[gregzz4]

I hate the white ones ... Sch40 are restrictive
Compare the insides of them against Sch80 and you'll see what I mean. Big difference

[Aquattro]

Water goes through holes, I'm happy.

[gregzz4]

Originally Posted by Aquattro

Water goes through holes, I'm happy.

Yup, it does.
Guess it all comes down to how much water you want to go through said holes

When planning plumbing I look at the fittings and see Sch40 cuts down flow considerably when it comes to unions/valves etc
Not my choice for parts, but to each his own. Or just what they can find locally

[Aquattro]

Yup. I simply need water to fall into sump, go back into tank. Done. The lumbing I have can support 5 times the flow I use, so whatever fitting home depot sells does the job. The entire plumbing job on my tank cost less than 20 bucks.

[helimech]

rona on south fraser in abbotsford will sell you shorter lengths, but they are a bit pricy

[Ryanerickson]

Originally Posted by gregzz4

I hate the white ones ... Sch40 are restrictive
Compare the insides of them against Sch80 and you'll see what I mean. Big difference

Greg think your confused sch80 pipe is a bit smaller inside but outside diameter is the same so sch 80 pipe will work with sch40 fitting. Sch80 fitting are same inside size but the outside of the fittings are bigger. Sch80 would be the most restricting but so little diffrence I think that's irrelevant. Also sch80is crazy overkill on aquariums unless your looking for the grey look your just wasting your money.in plumbing only time I really use sch80 PVC is under warehouses for potable water before they build. sch80 is super thick pipe therefore will not crack or break as easy plus less susceptible to freezing. I know your looking for a small piece but if you can not find it corix will sell you a full length for cheap and there all over bc good luck.

[The Guy]

Otter co-op @ 248th & Fraser Hwy sells short pieces of pvc.

[Aquattro]

http://www.sprinklerwarehouse.com/PV...-80-s/7615.htm

[gregzz4]

Originally Posted by Ryanerickson

Greg think your confused

There's always a possibility of that
Something from a few years ago is trying to come back to me.
I bought some parts from Rona, and some from Vancouver Irrigation.
I'd swear the skid40 from Rona had a smaller I.D. than the skid80 stuff from VI.

Didn't make sense to me at the time as 1" is 1". I realize they both accept the same pipe size.
I'm thinking it was a valve comparison. May have been between a ball and true union ball. Can't remember.