Anyone still using par 38 bulbs?

[FishyFishy!]

Not all models were dimmable, but all the newer ones should be. I bought 4 of the rapid led ones and they are great.

http://www.reefsupplies.ca/online-store/PAR38/

[Fishy!]

Well I picked up a halo par 38 from a local reefer today. Set it up on the tank and wow! Talk about shimmer! I will defineately have to keep the tank topped off to avoid havin a seisure lol. I find it quite blue but I'm sure it's just that I'm not used to it. I snapped a before and after.
http://imgur.com/a/xTVXW
It's actually not quite as blue as it shows on my iPhone but a drastic change none the less.
I have to say it doesn't seem as bright even as the single 8w t5 that came in the stock hood, but I'm guessing that's cause it's more concentrated? Less light spillage?
Will leave it on for a while and see how it goes. I will report back.

[Fishy!]

Also. The light I got is not dimmable with the Lurton dimmer I just bought from Home Depot. It just flashes when I move it from full power. The dimmer is supposed to be for cfl&led lights. Could be the wrong dimmer or could be an older model bulb. Either way on my 12.5x12.5x22" deep tank I don't think it needs to be dimmed.

[mike31154]

Originally Posted by Fishy!

Also. The light I got is not dimmable with the Lurton dimmer I just bought from Home Depot. It just flashes when I move it from full power. The dimmer is supposed to be for cfl&led lights. Could be the wrong dimmer or could be an older model bulb. Either way on my 12.5x12.5x22" deep tank I don't think it needs to be dimmed.

Is the Lutron dimmer an in wall type that fits into a normal electrical box? If so, pull it back out & check it for a small adjustment screw, usually at the top. Some have them, some don't but worth a look see & if it's there, tweaking it may get the LED to dim properly, but only if it is a dimmable PAR38 LED. If you can't dim it, you can raise it a little higher if you see signs of coral getting burned.

[mike31154]

Here's a Lutron dimmer with dimming 'range' control. There's a separate dial behind the faceplate that is used to fine tune how the dimmer works with a given lamp. Slightly different than the one I alluded to with a small adjustment screw at the top.

http://www.lutron.com/TechnicalDocum...ary/032365.pdf

[Fishy!]

http://www.homedepot.ca/product/cred...r-white/935870
^ That's the one I got. It's not adjustable.

[mike31154]

Originally Posted by Fishy!

http://www.homedepot.ca/product/cred...r-white/935870
^ That's the one I got. It's not adjustable.

Well then, the instructions for that one say the CFL or LED lamp used "must be marked as dimmable", so you need to confirm if your PAR38 LED is in fact dimmable or not. Chances are, it is not. Have a closer look at it, maybe get a part number & research it.