Scott's 135 gallon display tank build

[Gp Scott]

I am currently filling with ro- di water. I ordered my sand yesterday and talked with Eli with fijirock and he's working on some aquascapes for me. I still have a bit of work mounting and hooking up my Neptune controller and figuring that thing all out and mounting my refugium light that I purchased today as well

[Gp Scott]

I'm going to try the full syphon on my herbie not sure if it will work yet because my line runs horizontal in my floor for about 10 ft

[Gp Scott]

This is the light for my sump it's a Philips led par38 with 5000 k daylight with a out side flood light that is suitable for wet locations in just going to hang it.

[ronau]

Herbie should be just fine. It will take a bunch of tuning as it will change every time you change something in the system.

[Gp Scott]

Pic of my mag 24 surrounded in sponges hope it makes it quiet. On first test run with tap water I thought the pump was to loud might have to rap it back up in bubble rap.

[eli@fijireefrock.com]

Originally Posted by Gp Scott

Pic of my mag 24 surrounded in sponges hope it makes it quiet. On first test run with tap water I thought the pump was to loud might have to rap it back up in bubble rap.

I like your setup and cannot wait what aquas-cape you are coming up with..lol.
I am sure those sponges will disintegrate in saltwater as I seen it happen in the past.I recommend using styro only on the bottom of the pump and the sides if you like but make sure the pump when turned on is not hitting the glass and you should have a quieter sound.

[Gp Scott]

Originally Posted by ronau

Herbie should be just fine. It will take a bunch of tuning as it will change every time you change something in the system.

I hope your right I haven't tested it yet but I hope I can get all the air out of it. Or I have to go back to the durso that I had on there and insulate the line so I don't hear water running down the line.

[Gp Scott]

Originally Posted by eli@fijireefrock.com

I like your setup and cannot wait what aquas-cape you are coming up with..lol.
I am sure those sponges will disintegrate in saltwater as I seen it happen in the past.I recommend using styro only on the bottom of the pump and the sides if you like but make sure the pump when turned on is not hitting the glass and you should have a quieter sound.

Thanks for the info I will change the sponges out the wife was looking for them anyway lol. I have some pink rigid styrofoam in my garage that I will try. Looking forward to the aquascape.

[FishyFishy!]

I put a ball valve on the output side of my mag24. I dialed it back just a bit and it made it run dead silent. I recently did the same thing with my mag12, and it worked wonders. Something you could try. However you still need to dampen the vibration with foam/styro on the bottom of the pump.

[Gp Scott]

Originally Posted by FishyFishy!

I put a ball valve on the output side of my mag24. I dialed it back just a bit and it made it run dead silent. I recently did the same thing with my mag12, and it worked wonders. Something you could try. However you still need to dampen the vibration with foam/styro on the bottom of the pump.

I'm trying everything I put styrofoam in and notched it out so it sits down in it. I run it for a bit but still seams noisy like the impeller hitting something and lots of vibration. I have to wait to pump more water rodi making more. I have the mag 18 under sump and it's quiet I could swap pumps around but I'm not sure if I will have enough flow. 7C825FBBA03A_zpsw5sye0eg.jpg[/IMG]
I even insulated line out of pump and under header system connected to pump so nothing vibrates on glass